News -

Home / News (Page 3)

The reason why the extruder screw suddenly does not turn
18 Jan 2019
During the extrusion process, there may be a phenomenon that the extruder screw/suddenly stuck. At this point, if the extruder protection does not work, the operator should stop im...
What is the job of the extrusion screw maintenance?
11 Jan 2019
When the extrusion screw is in the process of continuous operation, its internal parts can not avoid wear and then directly lead to a decrease in production efficiency. In response...
Extruder barrel screw and mold maintenance
04 Jan 2019
First, the extruder barrel screw and mold maintenance Before the extruder is stopped, the mold should be turned to a condition of 5-10mm interval, so that the hinged (curved arm) s...
Causes and countermeasures for common damage to extruder screw and barrel
28 Dec 2018
The extruder screw and barrel are the soul components of the extruder. Their combination is related to the working quality of the extruder, the plasticizing ability of the material...
What is the parallel twin-screw extruder drive?
21 Dec 2018
The parallel twin-screw extruder transmission device is a hard-tooth surface high-precision transmission device matched with a different outward-rotating parallel twin-screw extrud...
What are the structural characteristics of the twin-screw extruder?
13 Dec 2018
(1) Meshing type co-rotating twin-screw extruder: Since the speed of the co-rotating twin-screw at the meshing position is opposite, one screw pulls the material into the meshing g...